VNA GUI reference
R&S
®
ZNL/ZNLE
464User Manual 1178.5966.02 ─ 20
10.11.2 Multiple Peak tab
"Multiple Peak" search allows you to find multiple local minima/maxima at once.
Background information
Refer to "Basic marker search functions" on page 202.
10.11.2.1 Controls on the Multiple Peak tab
Max / Min
Sets up to 10 markers to the highest maxima or lowest minima in the configured Eval
Range. If a complex trace format is active (e.g. a polar diagram), the markers are set to
the measurement points with the maximum or minimum magnitude.
The required markers are created/deleted as needed.
Remote command:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute MMAXimum | MMINimum
CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:EXECute MMAXimum |
MMINimum
CALCulate<Chn>:MARKer<Mk>:FUNCtion:RESult?
CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:RESult?
Eval Range
Opens the Evaluation Range dialog that allows you to set the domain for the multiple
peak search. A modified domain takes effect the next time Max / Min is used.
Tracking
Enables or disables tracking for "Multiple Peak" search. If enabled, a new multiple
peak search is performed for each sweep (creating/deleting markers as needed).
Define an Eval Range to restrict the search to the adequate frequency or power inter-
val.
Remote command:
CALCulate<Chn>:MARKer<Mk>:SEARch:TRACking
Marker Search softtool
To Next Page
Loading...
