Operating modes, applications, channel setups, and result displays
R&S
®
ZNL/ZNLE
86User Manual 1178.5966.02 ─ 20
The "I/Q Analyzer" application requires a R&S ZNLxx equipped with the spectrum
analysis hardware option R&S ZNLxx-B1.
Note: For the R&S ZNLE and for R&S ZNL14 and R&S ZNL20 with serial numbers
below 101200, a spectrum analysis hardware option is not available.
The "I/Q Analyzer" application is described in the R&S ZNL "I/Q Analyzer" User Man-
ual.
Remote command:
INST:SEL IQ, see INSTrument[:SELect] on page 571
Analog Demod
The Analog Demodulation application provides measurement functions for demodulat-
ing AM, FM, or PM signals.
The "Analog Demod" application requires a R&S ZNLxx equipped with the spectrum
analysis hardware option R&S ZNLxx-B1, plus the "Analog Demodulation" software
option R&S FPL1-K7.
Note: For the R&S ZNLE and for R&S ZNL14 and R&S ZNL20 with serial numbers
below 101200, these options are not available.
For details see the Analog Demodulation Mode User Manual.
Remote command:
INST:SEL ADEM, see INSTrument[:SELect] on page 571
Noise Figure
The Noise Figure application provides noise figure measurements.
The "Noise Figure" application requires a R&S ZNLxx equipped with the spectrum
analysis hardware option R&S ZNLxx-B1 plus the "Noise Figure Measurements" soft-
ware option R&S FPL1-K30.
Note: For the R&S ZNLE and for R&S ZNL14 and R&S ZNL20 with serial numbers
below 101200, these options are not available.
For details see the Noise Figure Measurements User Manual.
Remote command:
INST:SEL NOISE, see INSTrument[:SELect] on page 571
5.2 R&S MultiView
Each application is displayed in a separate tab. If more than one application is active,
an additional tab ( "MultiView" ) provides an overview of all currently active channel
setups at a glance. In the "MultiView" tab, each individual window contains its own
channel setup bar. Select the channel setup bar to switch to an application quickly.
R&S MultiView
To Next Page
Loading...
