VNA GUI reference
R&S
®
ZNL/ZNLE
349User Manual 1178.5966.02 ─ 20
Disable all other Measurements/Enable all Measurements
Toggle button with alternating caption.
"Disable all
other Measure-
ments"
●
Disables all channels, except the active one
●
Disables all traces in the active channel, except the active one
●
Hides all diagrams except the active one
"Enable all
Measure-
ments"
Restores the previous channel/trace/diagram configuration
Same functionality as the
10.6.1.2 Trace Manager dialog
The "Trace Manager" dialog allows you to perform operations on traces.
Access: [Trace] > "Traces" > "Trace Manager..."
All existing traces of the current channel setup are listed in a table with several editable
(white) or non-editable (gray) columns.
Table Area
The table contains the following columns:
●
"Name" indicates name of the related trace.
Trace names must be unambiguous across all channels and diagram areas in a
channel setup.
●
"On" indicates and controls the visibility of the related trace.
●
"Label" indicates and controls the visibility of the related trace label
●
"Meas" indicates the measured parameter.
●
"Type" indicates whether the trace is a data trace ("DAT"), displaying the current
measurement data, or a memory trace ("MEM").
●
"Channel" indicates and controls the channel to which the related trace is assigned.
Data traces and their associated memory traces are always assigned to the same
channel.
●
"Diagram" indicates and controls the diagram area to which the related trace is
assigned.
●
"Scale" indicates and controls the scale coupling of the related trace.
A trace's scaling can either be uncoupled ("Scale" empty) or coupled to another
trace's scaling.
Rules for trace names
Trace softtool
To Next Page
Loading...
