R&S ZNLE Series - Page 510

VNA GUI reference
R&S
®
ZNL/ZNLE
510User Manual 1178.5966.02 ─ 20
10.12.3.1 Controls on the Power Cal Settings tab
Some buttons serve as openers for additional dialogs:
●
"Power Meters...": see Chapter 9.7.14, "Power sensor measurements (R&S ZNL
only)", on page 306
●
"Power Meter Config...", see Chapter 10.12.3.5, "External Power Meter Config dia-
log", on page 520
This button is active only if at least one external power meter is online (physically
connected, switched on, ready to be used).
Switch Off Other Sources
Ensures that the power at all sources except the calibrated source is switched off dur-
ing the calibration. Recommended, if the measurement involves a combination of dif-
ferent signals.
Remote command:
SOURce<Ch>:POWer:CORRection:OSOurces[:STATe]
Flatness Cal – Max Iterations
Sets a limit for the number of calibration sweeps. See also "Calibration procedure"
on page 273.
Remote command:
SOURce:POWer:CORRection:NREadings
SOURce:POWer:CORRection:COLLect:AVERage[:COUNt]
Cal softtool