R&S ZNLE Series - Page 799

Command reference
R&S
®
ZNL/ZNLE
799User Manual 1178.5966.02 ─ 20
ISMith Displays z in an inverted Smith diagram
GDELay For frequency sweeps only
Calculates the group delay at the related sweep
point and displays it in a Cartesian diagram
REAL Calculates Re(z) = x and displays it in a Cartesian
diagram
IMAGinary Calculates Im(z) = y and displays it in a Cartesian
diagram
SWR Calculates the standing wave ratio (1 + |z|) / (1 - |z|)
and displays it in a Cartesian diagram
LOGarithmic Displays z in a Cartesian diagram with logarithmic
scale
CALCulate<Chn>:FORMat:WQUType <Unit>
Selects the physical unit of the displayed trace.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Unit> POWer | VOLTage
Power or voltage units
*RST: POWer
Example:
CALC4:PAR:SDEF 'Ch4Tr1', 'b1'
Create channel 4 and a trace named Ch4Tr1 to measure the
wave quantity b
1
. The trace becomes the active trace in channel
4.
CALC4:FORM:WQUT VOLT
Select voltage units for the created trace (identified by the suffix
4).
Manual operation: See "Show as" on page 407
CALCulate<Chn>:GDAPerture:SCOunt <Steps>
Defines an aperture for the calculation of the group delay as an integer number of fre-
quency sweep steps.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Steps> Number of steps
Range: 1 to 10000
*RST: 10
VNA command reference