R&S ZNLE Series - Page 818

Command reference
R&S
®
ZNL/ZNLE
818User Manual 1178.5966.02 ─ 20
Manual operation: See "Diagrams / Rows / Columns" on page 427
DISPlay:LAYout:JOIN <MainLayoutId>, <DiagramNumber>, <SubLayoutId>
Creates a nested layout, inserting a sub-layout into one of the diagrams of a main lay-
out. Main layout and sub-layout must be defined previously, preferably using
DISPlay:LAYout:DEFine.
Note: The maximum number of joined levels within a layout is 16.
Setting parameters:
<MainLayoutId> Integer value 1, 2 ...
Current number of main layout, as defined by DISPlay:
LAYout:DEFine.
<DiagramNumber> Integer value 1, 2 ...
Diagram number in the main layout
<SubLayoutId> Integer value 1, 2 ...
Current number of sub-layout, as defined by DISPlay:
LAYout:DEFine.
*RST: n/a
Example: See Creating diagrams
Usage: Setting only
Manual operation: See "Additional Functionality: SCPI Commands" on page 427
DISPlay:LAYout:OVERlay
Displays all traces of the active channel setup in a single diagram, which is maximized
to occupy the whole screen.
Usage:
Event
Manual operation: See "Overlay All" on page 424
DISPlay:LAYout:SPLit
Creates a separate diagram for each trace in the active channel setup and automati-
cally arranges those diagrams in the diagram area. Existing diagrams are deleted.
Usage:
Event
Manual operation: See "Split All" on page 424
DISPlay:RFSize <RelFontSize>
Defines the size of the fonts in the diagram on a relative scale.
VNA command reference