5 | Setup
40 / 84 80.06.083_iCombi Pro-iCombi Classic_IM_V01_en-US
2. Check that the support rack trolley enters the device straight. If this is not
the case, use an entry ramp or drive-over aids.
Entry ramp and drive-over aid
n
If the ground is not level, the unevenness must be compensated by an en-
try ramp.
n
If there is a drain grille in front of the floor device, install a drive-over aid in
the entry area of the support rack trolley.
Storage of the handle
The included holder provides safe storage of the handle for the support rack
trolley during cooking.
1. Attach the handle holder to the top of the device so that the holder faces
the left side panel.
2. Hang the handle in the holder.
To Next Page
Loading...
Need help?
General
