ROUBLESHOOTING
T
14 68233 46-R3
2.4-2 Wire Harness
Complete
Voltage
6 VDC
Display
reacts
Display
reacts
Check load cell calibration board.
Without touching contact points,
move board or cables.
Battery holder is faulty,
replace wire harness
Cable or connector
is damaged or has
oxidized
Contact is bad
Check cables, especially where the
cable enters the load cell connector.
Move the cable and observe the display.
With fully charged batteries
and the iFork assemblies
switched on, check the
voltage of battery holder.
YES
YES
YES
NO
NO
NO
Start
To Next Page
Loading...
