56823346-R3
ROUBLESHOOTING
T
Error Messages
Low Battery Messages
Display Shows: Meaning:
BltF1 Successful connection with Fork 1
BltF2 Successful connection with Fork 2
Other Display Messages
Low Battery
Indicators
2.2 Display Messages
Display
Shows: Meaning: To Exit Error Mode:
Err01 Load cell signal is unstable. Automatic
Err02 iForks are overloaded. Automatic after removing weight
Err03 Gross weight is negative. This action is not allowed. Automatic
Err04 Out of zero range. Press any button
Err05 Sampling accuracy too low. Press any button
Err06 Input signal too high. Automatic after correcting input
Err08 Calibration out of range (negative). Automatic
Err09 Calibration out of range (signal too low). Automatic
Err10
Calibration count 2nd (3rd) point is lower than count 1st (2nd)
point.
Automatic
Err14 Calibration setpoint value 2 < setpoint value 1. This is not allowed. Automatic
Err97 NTEP (OIML) only: Calibration not allowed.
Press "On/Off" button two times. Contact
Cascade Service if calibration is required.
Err98
Entered weight used for weight calibration must be higher than
previous entered weight.
Automatic
Err99 Button pressed or another action is performed while toggling
between units format (lb or kg).
Wait for display to return to original unit
format (lb or kg).
ErrF1 Problem with iFork 1 (no communication). Restart display. Restart iForks & display.
ErrF2 Problem with iFork 2 (no communication). Restart display. Restart iForks & display.
----- Load cell signal negative. Lift up the forks from the ground
L - _ Forks are out of level (only legal for trade version) Put the forks into horizontal position
ErrCS Problem with correction sensor Contact the Cascade Service department
Display
Shows: Meaning: To Exit Error Mode:
Battery of display is low Replace or recharrge the 4 AA batteries
+F1 Fork 1 battery is low
Recharge battery packs or replace the
D cells in both battery packs.
+F2 Fork 2 battery is low
Recharge battery packs or replace the
D cells in both battery packs.
▼
▼
To Next Page
Loading...
