2
Manual No. 016-0159-822 Rev E 9
INTRODUCTION
Based on these calculations and a PSI of 30, tip XR8004 should be selected since it comes closest to providing the
desired output.
VERIFYING FLOW RATE LIMITS
The flow rate of spray must be within the specified range for the flow meter being used..
NOTE: Only Krohne Magmeters sold through Raven Industries should be used with Raven controllers. No
other Krohne Magmeters are supported.
Target Speed 5.2 MPH (km/h)
Nozzle Spacing 20 inches (cm)
20 GPA x 5.2 MPH x 20 inches = .35 GPM
5,940
Flow Meter Model Flow Range
RFM 5 0.1 - 5 GPM [0.2 - 18.9 lit/min]
RFM 15 0.3 - 15 GPM [1.1 - 56.8 lit/min]
RFM 60P 1 - 60 GPM [3.8 - 210 lit/min]
RFM 60S 1 - 60 GPM [3.8 - 210 lit/min]
RFM 100 5 - 100 GPM [18.9 - 380 lit/min]
RFM 200/200 Poly 15 - 200 GPM [56.8 - 760 lit/min]
Magmeter 200 3 - 200 GPM [11.36 - 757 lit/min]
RFM 400 25 - 400 GPM [94.6 - 1515 lit/min]
Krohne 3” Magmeter* 15 - 250 GPM [56.78 - 946.25 lit/min]
Krohne 4” Magmeter* 35 - 1,800 GPM [132.48 - 6813 lit/min]
Krohne 6” Magmeter*
70 - 3,000 GPM [264.95 - 11,355 lit/
min]
To Next Page
Loading...
