Raven SCS 440 User Manual

CHAPTER 5
36 SCS 440 Serial Interface Installation & Service Manual
SCS 440 Console to Remote Computer Data Strings
All request strings begin with $R, indicating a Raven communication string. In the example below, the 124 value
indicates the last three digits of the programmed chip part number in the console, and F is the software revision
letter of the console.
Calibration strings=$R124F, C1, <switch_byte_1>, <switch_byte_2>, <boom_1_cal>, <boom_2_cal>,
<boom_3_cal>, <boom_4_cal>, <boom_5_cal>, <boom_6_cal>, <speed_cal> <CR> <LF>
=$R124F, C2, <meter_cal>, <CR> <LF>
=$R124F, C3, <valve_cal>, <rate_1_cal>, <rate_2_cal> <CR> <LF>
Data Strings=$R124F, D1, <total_area>, <field_area> <CR> <LF>
=$R124F, D2, <total_volume>, <field_volume> <CR> <LF>
=$R124F, D3, <tank_volume>, <distance> <CR> <LF>
Actual Rate=$R124F, AR <actual_rate> <CR> <LF>
Time/Date=$R124F, TD, <hr:min>, <month/day/year>, <field_reference> <CR> <LF>
SELF TEST FEATURE
The self test feature simulates speed so that the system may be tested without moving. The self test feature will
clear itself when vehicular motion is detected by the speed sensor. A speed cal value of 900 [230] or greater is
recommended when operating in this mode.
NOTE: To prevent the self-test speed from clearing itself out automatically, disconnect the speed connector
on the back of the console when radar speed sensors are used.
1. Press the SELF TEST button.
2. Enter the desired simulated speed value.
3. Verify the vehicle’s speed by pressing the SPEED button.
Bit Switch Byte 1 Switch Byte 2
0boom 1 0
1boom 2 0
2boom 3 0
30 rate 1
40 rate 2
50 0
60 0
71 1
Note: If rate 1 and rate 2 are both zero, the console is in
Manual mode. For switch bytes, 0 = off and 1 = on.

Raven SCS 440 Specifications

General

Brand	Raven
Model	SCS 440
Category	Recording Equipment
Language	English