Raymarine i50 Depth - Mounting Procedure

5.1Mounting
Pre-mountingcheck
Theproductisdesignedtobesurfacemounted.
Beforemountingtheunit,ensureyouhave:
•Selectedasuitablelocation.
•Identiedthecableconnectionsandroutethatthe
cableswilltake.
•Detachedthefrontbezel.
•Removethekeypadmat.
Mountingdiagram
D12 3 79-1
Mountinginstructions
1.Checktheselectedlocationfortheunit,aclear,
atareawithsuitableclearancebehindthepanel
isrequired.
2.Fixthemountingtemplatesuppliedwiththe
product,totheselectedlocation,usingmasking
orselfadhesivetape.
3.Ifpossibleuseanappropriatesizeholecutting
sawandcutoutthecentreholecutoutareaas
indicatedonthemountingtemplate,or
4.Usingasuitableholecuttingsaw,makepilot
holesineachcornerofthecutoutareaandusing
ajigsawcutalongtheinsideedgeofthecutout
line.
5.Ensurethattheunittsintotheremovedarea
andthenlearoundthecutedgeuntilsmooth.
6.Drillanyrequiredholesasindicatedonthe
mountingtemplateforthesecuringscrews.
7.Connecttherelevantcablestotheunit.
8.Peelthebackingoffofthesuppliedgasketand
placetheadhesivesideofthegasketontothe
displayunitandpressrmlyontotheange.
9.Slidetheunitintoplaceandsecureusingthe
screwsprovided.
10.Retkeypadmatandfrontbezel.
Note:Drill,tapsizeandtighteningtorquesare
dependantuponthematerialtypeandthickness
ofthemountingsurface.
Note:Thesuppliedgasketprovidesaseal
betweentheunitandasuitablyatandstiff
mountingsurfaceorbinnacle.Thegasketshould
beusedinallinstallations.Itmayalsobe
necessarytouseamarine-gradesealantifthe
mountingsurfaceorbinnacleisnotentirelyatand
stifforhasaroughsurfacenish.
30i50