V1.0 Raytools AG © Copyright
3
|24
www.raytools.ch
BS06K 6kW All-In-One Smart Laser Cutting Head - User Manual
Safety Instructions
Prevent Electric Shock
▪ Parts of the laser head such as the nozzle, sensor, sensor interface, and attached fasteners may not be
fully protected by the ground wire due to function fault. These parts may have low voltage. When installing
electrical equipment, please pay attention to taking anti electric shock measures for relevant personnel.
▪ Note that the equipment shall be grounded as specified.
Guard against Danger
▪ Never put your hands or other body parts under the laser head.
▪ Repair and maintenance can only be carried out after power off.
▪ Do not exceed the specified maximum pressure.
▪ Must ensure the laser head is in normal condition at all times.
▪ All fasteners such as bolts and nuts must be tightened.
Laser Caution
▪ Avoid direct laser radiation or scattering to the skin.
▪ Do not stare at the laser beam even when wearing optical equipment.
▪ Use special laser goggles that meet the requirements of related safety standards IEC 60825-1.
Prevent Water Circuit Corrosion
▪ To avoid corrosion, use the specified coolant and comply with relevant requirements and specified maintenance
intervals.
Noise Prevention
▪ The corresponding measures shall be specified or explained and observed to prevent personnel from being
harmed by noise.
Storage and Transportation
▪ Observe the storage temperature range allowed by the technical data.
▪ Take reasonable measures to prevent fire, vibration, or impact.
▪ Do not store in or near the magnetic field
.
To Next Page
Loading...
