Chapter 1 - GENERAL INFORMATION AND SAFETY
RC GROUP S.p.A I_TRP_0909_GB
10
Use the machine only for the purposes recommended by the
manufacturer. Using the machine for any improper job may result in
serious safety and health hazard and financial damage.
The machine has been designed and manufactured in such a way that
it can satisfy all the working conditions indicated by the manufacturer.
Tampering with any device in order to obtain any different performance
may result in safety and health hazard and financial damage.
Do not use the machine if the safety devices have not been perfectly
installed and are not effective. Failure to meet this requirement may
result in serious safety and health hazard.
Keep the machine in perfect working order, carrying out the scheduled
maintenance jobs recommended by the manufacturer.
Proper maintenance will ensure better performance, longer life, and the
constant maintenance of safety requirements.
Before carrying out any regulation and maintenance job on the
machine, activate all the safety devices provided and consider whether
the personnel involved and the operators nearby must be informed
properly or not. In particular, carefully indicate the neighbouring areas
and prevent the access to all devices that, if activated, are likely to
cause unpredictable dangers, causing damage to people’s safety and
health.
The regulation and maintenance jobs must be effected by authorized
operators, who must arrange all the necessary safety conditions,
according to the procedures indicated by the manufacturer.
All maintenance jobs that require any specific technical skill or expertise
must be carries out only by qualified personnel, adequately experienced
in the relevant sector of intervention.
To carry out any maintenance jobs in areas that are difficult of access
or dangerous, ensure proper safety conditions for yourself and for other
people, according to the applicable industrial safety laws.
Replace any worn components with original spare parts only. Use the
oils and greases recommended by the manufacturer, so as to ensure
the machine performance and the expected safety level.