INDEX
RC GROUP S.p.A. I_TRP_0909_GB
2
1 GENERAL INFORMATION AND SAFETY............................ 4
1.1 OBJECTIVE OF THIS MANUAL ............................................. 4
1.2 GLOSSARY AND TERMS ...................................................... 5
1.3 MANUFACTURER AND MACHINE IDENTIFICATION .......... 6
1.4 INTERPRETATION OF THE MODEL’S CODE ...................... 7
1.5 REQUEST FOR ASSISTANCE .............................................. 7
1.6 ENCLOSED DOCUMENTATION ........................................... 8
1.7 SAFETY REGULATIONS ....................................................... 8
2 TECHNICAL INFORMATION .............................................. 11
2.1 GENERAL DESCRIPTION OF THE MACHINE .................... 11
2.2 DESCRIPTION OF THE MAIN COMPONENTS AND
WORKING PRINCIPLE ....................................................... 12
2.3 OPTIONAL DESCRIPTION .................................................. 16
2.4 SAFETY DEVICES ............................................................... 16
2.5 TECHNICAL DATA .............................................................. 16
3 HANDLING AND TRANSPORTATION INFORMATION ..... 17
3.1 TRANSPORTATION ............................................................ 17
3.2 PACKING AND UNPACKING ............................................... 17
3.3 HANDLING AND LIFTING .................................................... 18
4 INSTALLATION AND TESTING INFORMATION ............... 19
4.1 SAFETY FOR INSTALLATION AND TESTING .................... 19
4.2 INSTALLATION AREA ......................................................... 19
4.3 DIMENSIONS OF THE PERIMETRICAL AREA ................... 19
4.4 PRESETTING THE CONNECTIONS ................................... 19
4.5 INSTALLING THE MACHINE ............................................... 20
4.6 HYDRAULIC CONNECTION TO THE PLANT HEAT
EXCHANGER ...................................................................... 21
4.7 HYDRAULIC CONNECTION TO THE EXHAUST HEAT
EXCHANGER ...................................................................... 23
4.8 HYDRAULIC CONNECTION TO THE DOMESTIC WATER
EXCHANGER ...................................................................... 25
4.9 CLEANING AND FILLING THE HYDRAULIC CIRCUITS ..... 27
4.10 ELECTRICAL CONNECTION .............................................. 27
4.11 PRE-COMMISSIONING PROCEDURES ............................. 28
4.12 COMMISSIONING PROCEDURES ..................................... 29
5 CALIBRATION AND TUNE-UP INFORMATION ................. 30
5.1 CALIBRATION AND TUNE-UP PROCEDURES .................. 30
To Next Page
Loading...