RC GROUP TRIPACK Series - Calibration and Tune-Up Information; Calibration and Tune-Up Procedures

Chapter 5 - CALIBRATION AND TUNE-UP INFORMATION
RC GROUP S.p.A I_TRP_0909_GB
30
5 CALIBRATION AND TUNE-UP INFORMATION
5.1 CALIBRATION AND TUNE-UP PROCEDURES
Upon the commissioning of the machine, after any failure or
replacement, upon any ordinary or extraordinary maintenance jobs, the
operation checking devices could need a re-calibration or tune-up.
These jobs (the most important are listed below) must be effected by a
specialized Engineer:
– Expansion valve calibration.
– Water flow calibration
– Calibration of the refrigerant circuit parameters.
– Microprocessor calibration.