Chapter 6 - INFORMATION FOR USE
RC GROUP S.p.A I_TRP_0909_GB
31
6 INFORMATION FOR USE
6.1 RECOMMENDATION FOR USE
The day-to-day use of the plant does not require the Operator’s
presence: he must intervene to conduct periodical checks, in an
emergency or to carry out the foreseen start-up and stop stages.
The regular and constant execution of these jobs will allow the machine
and the plant to deliver proper performance over the time.
WARNING - CAUTION
Failure to comply with these procedures may be a cause of poor
performance of the machine/plant as a whole and of wear.
6.2 CONTROLS DESCRIPTION
The various controls are shown below, as well as their description and
function. These controls are positioned on the switchboard, that can be
accessed opening the external door.
Door locking switch: opens
and closes the power circuit.
- OFF (0) position: the
machine is not powered.
- ON (I) position: the
machine is powered.
Microprocessor: controls the
working process and allows the
parameter setting and the
monitoring the working
conditions.
More detailed instructions are
reported in § 6.3 and 6.4.
To Next Page
Loading...