Chapter 6 - INFORMATION FOR USE
RC GROUP S.p.A I_TRP_0909_GB
37
6.8 DISPLAYING THE HOUR-METER AND MAINTENANCE ALARM
1. Press 5 key to access to the main
control functions menu.
2. Press 7 key to run the menu up to
“HISTORY”.
3. Press 8 key to enter menu.
4. Press 7 key to display the mask as shown in the picture.
5. 5 Press 7 keys to run pages in the menu.
6. The alarm “Maintenance” is activated when the running hours of the
component reach the set value (Programmable parameters by
Skilled Engineer) and informs the end user about components
maintenance need.
To reset the working hours act as follows:
7. Press 8 key to move the cursor under (R) letter (Reset).
8. Press 7 key for 6 secs minimum to reset working hours.
9. Press 4 key to go back to the main menu.
6.9 DATE AND TIME SETTING
IMPORTANT
The function can be activated only when clock card “CK” is
installed.
1. Press 5 key to access to the main
control functions menu.
2. Press 7 key up to “CLOCK SET” is
displayed.
3. Press 8 key to menu access. Press
again to change value.
4. Press 7 key to decrease the value; press 6 key to increase the value.
5. Press 8 key to store the value.
Hour / pulse meter 1/2
UNIT 000000 h R
PUMP 1 000000 h R
PUMP 2 000000 h R
Clock and date setting
time 15:35 Sun
date 21/01/07
To Next Page
Loading...
General