RCm BYTE - Washer-Drier Preparation; Battery Installation; Solution Tank Filling

2929
ITALIANO
WASHER-DRIER PREPARATION
(FIG.2)
Squeegee assembly
For packaging reasons the squeegee might have been supplied dismantled from the machine. Assemble the squeegee on the washer-drier
tow plate as follows:
- lower lever 1
- insert pins 2 on the tow plate 3 and tighten the knobs 4
- assemble the suction tube 5 on the squeegee.
Squeegee regulation
For maximised functioning of the squeegee, the back blade “A” must be slightly bent during operation.
In this way liquids are collected by the front side of the blade. Regulate the incline of the squeegee by means of the knob 6, looking for the
best angle with respect to the fl oor (as shown in the fi gure). Regulate as follows:
- clockwise rotation increases incline
- counter-clockwise rotation decreases incline
BATTERY INSTALLATION
(FIG.3)
!
ATTENTION!
I
F THE BATTERIES TO BE INSTALLED ARE GEL OR LEAD, PERFORM SPECIFIED SETTINGS ON “DIP SWITCH” 1 LOCATED ON
THE ELECTRONIC CONTROL UNDER THE CONTROL PANEL. “THE SETTINGS CAN BE FOUND IN THIS MANUAL, SEE
FIGURE A”.
The batteries are placed in their special bay in the solution tank, which can be accessed by releasing the drainage tube 1 and removing the
recovery tank 3.
Proceed as follows to install batteries:
- verify that the recovery tank is completely empty
- remove the tank
- insert and connect batteries as represented in battery connection diagram 4
- replace the recovery tank and re-attach the drainage tube.
!
ATTENTION!
CHARGING GEL OR LEAD BATTERIES (SEE ”WASHER-DRIER MAINTENANCE – CHARGING BATTERIES)
SOLUTION TANK FILLING
Verify that the recovery tank is completely empty.
Fill the solution tank via the mouth 9 (fi g.1) to deposit clean water at a maximum temperature of 50°C, add diluted liquid cleanser in the
concentration dosage recommended by the manufacturer.
To avoid the formation of excessive foam, we recommend using the minimum amount of suggested cleanser or adding an anti-foam
product.
Always utilise protective gear (gloves, shirts, etc.) when handling detergents or when emptying the tank of recovery liquid.
!
ATTENTION!
ALWAYS USE ANTI-FOAM DETERGENTS, USE LOW-DANGER DETERGENTS AND REFER TO THE MANUFACTURER INFORMATION SHEET.
DO NOT USE UNDILUTED ACID.
ENGLISH