DIGITAL INCUBATOR
3. Incubation
(1) Incubator Installation
Test the incubator to be sure that the incubator works without any problem before placing eggs in the incubator.
Please ensure you remember how to use the machine and maybe re-read instructions.
power cord
pump -
power cord
ⓐ
14
Incubator Installation
▶ Open the power cap, and insert the incubator power cord
and pump power cord.
Be careful to ensure the cords do not get jammed
when you tighten screw bolt.
If you open power cap, there is a sticker which is
showing rated current in the position of pic.ⓐ.
▶ Connect silicon tube end of APS (Automatic
Pumping System) into the nipple of incubator,
and the other end into PET bottle.
▶ Be sure to check rated current Pic.ⓐ before
connecting power cord to outlet.
▶ Press button for about 10 sec.
for pump operation, and it automatically
stop after 2min. If you want to stop pump
operation, press any key.
If you do not insert silicon tube exactly,
it will not work properly.
[Refer to the page 11. How to replace
silicon tube.]
POWER INLET
PUMP POWER
OUT
IN
Pump Power
Power Cord
Pump Power
Power Cord
USA & Canada Official Sales & Service https://www.R-Com-Hatcher.com
Insect Incubator Rcom Max 70 User Manual
To Next Page
Loading...
