POWER INLET
PUMP POWER
2. Before use
DIGITAL INCUBATOR
OUT
IN
(1) What is an incubation Room?
(2) How to Assemble
Incubation room? It means the place where the incubator is installed and operated, and as it has much effect on
incubation rate according to the environment of incubation room, it is good to install incubator at the place where
there is little noise and vibration in the vicinity and the temperature range isn’t severe in the temperature of 22~25
℃
(71.6~77℉). In particular, as there are many cases that the temperature falls rapidly in the nighttime differently
from the daytime, it is necessary to check certainly, and during daytime, incubator must not be exposed directly to
the sunlight.
What is an Incubation Room?
When the temperature of incubation room is lower than, recomended setting temperature there could be
water-droplets in side of incubation room or water leak on the floor. because of dew condensation.
How to Assemble
Pump PowerPump Power
Power CordPower Cord
▶ Please remove all packing from the incubator and parts.
Then, check each part is present and undamaged.
(Please keep the carton and packing materials for repac
king to retain the incubator in good condition when not
using.)
▶ (EX:RCM0000000) If you register your information with
your machine’s serial number on our web-site(www.
Rcom.co.kr), you can get 2 year warranty service.
[Refer to the page 24]
[ How to Assemble Main Body ]
8
USA & Canada Official Sales & Service https://www.R-Com-Hatcher.com
Insect Incubator Rcom Max 70 User Manual
To Next Page
Loading...
