EC9000i / 9100i / 9600i Series Scanner User Guide Setting up your scanner
Connecting the power cord
1. Align the flat side of the power connector so that it is facing up.
2. Insert the round end of the power cord into the power port on the back of the scanner.
When the cord is pushed in completely, it clicks into place.
3. With the power cord connected to the power adapter, plug the other end of cord into an electrical
outlet.
Disconnecting the power cord
Caution: Disconnecting the scanner from a power source while the scanner is processing a transaction
might cause data loss.
The power cord has a sleeve on it that secures it to the unit. The security sleeve prevents the power cord
from being pulled out of the unit accidently.
1. Hold the unit in place with one hand to prevent the unit from falling.
2. With your other hand, slide the power cord security sleeve back and pull the power cord free of
the scanner.
Installing cartridges and paper roll
For installing the franker cartridge, see Replacing the franker cartridge on page 27.
For installing the endorser inkjet cartridge, see Replacing the endorser inkjet cartridge on page 27.
For installing the paper roll, see Replacing the paper roll for the printer on page 29.
Drivers and Applications
There are many applications that support the RDM EC9000i / 9100i / 9600i scanners. Most are available
from third-party vendors. If you are not sure where to acquire your check scanning application, check with
whoever provided your scanner.
The drivers for RDM EC9000i / 9100i series scanners are installed on your computer when you install the
check scanning application.
EC9600i scanning application requirements
The EC9600i series scanners do not require that you install any drivers on your computer. However,
depending on your scanning application, there might be some additional setup required for the application
to connect to the scanner. For example, you might need to:
• Install a security certificate on your computer.
• Make changes to your browser’s security settings.
For more information about EC9600i setup requirements, see your scanning application’s documentation.
©2015 RDM Corporation Page 18
To Next Page
Loading...
