WEIGHING
15
4.5 Load Alarm
Default: - Alarm Off
The instrument has a Load Alarm function. If the load exceeds a preset figure
set in CAL Mode 2 (6.2.6), an audible alarm is triggered and the weight
display will flash.
The alarm will continue and weighing is not possible until the overload
condition ceases. The load alarm is operative at any lift position.
4.6 Printing
Printing a Channel total (Channels 1 to 5)
Select the appropriate channel then
press the button to print the total
weight that has been recorded to that
channel since it was last reset.
If the printer mode is set to “REC”, a short
“Job Record” will be printed. (Fig. 13).
If the printer total is set to “ROLL”, a “Job
Record” will be printed with space for the
customer name, address and signature
(Fig. 14).
NOTE: Pressing the ZERO button will cancel
routine.
Printing a Grand Total
Select channel 6 and press the button
to print a “Totals Summary” of the
individual totals for channels 1 to 5, and
the Grand Total recorded to channel 6
(Fig.15a).
NOTE: Pressing the ZERO button will cancel
routine.
Figure 13 : A Job Record (“REC”)
Figure 14 : A Job Record (“ROLL”)
To Next Page
Loading...
Need help?
General