RDS Technology Weighlog 200 - Page 20

CALIBRATION
20
3.4
Set Zero
(with empty bucket)
6.2.2
Set Weighing Mode
(“
dYn
” or “
StAt
”)
6.2.3
Set Initial Cal Factor
(= Max. Load Capacity in tonnes)
6.2.4 (i)
6.2.4 (ii)
Weight Cal. Routine
DYN. MODE STAT. MODE
“Load FASt” Fast lift (full load)
“Load Slo” Slow lift (full load)
“Empt FASt” Fast lift (empty bucket) (note 1-p.18)
“Empt Slo” Slow lift (empty bucket)
“ZERO LIFT” – Sets Prop. Scaling/Speed “ZERO LIFT”
Comp. for all dynamic channels Lift empty bucket
Determine Cal Factor (the “LOAD” sequence)
Enter known weight on instrument
“LOAd LIFt”
Place a known weight in the bucket and lift at normal speed
“DONE”