Installing the iPad Mount and App Recon Blockage Plus™ Installation Manual
600840-000069, rev 1.0 Page 28 of 35
Connecting to the Gateway
1. Make sure that you have power to the gateway. The gateway’s LED is green when it’s
done booting.
2. Tap the Settings icon on your iPad’s home screen.
3. Tap Wi-Fi. Then, connect to the Gateway-XXXXXX network (if it’s your first time using
the system) or the IASBlockage network
“XXXXXX” represents the gateway’s serial number.
4. Open the Recon Blockage Plus app from the iPad’s Home screen. Follow the on-screen
prompts to begin configuring your system
For instructions to configure and use Recon Blockage Plus™ after installation, see the Recon
Blockage Plus Operator’s Guide (600890-000015) from the app’s Manuals screen.
To Next Page
Loading...