To Next PageTo Next Page
Need help?Do you have a question about the Record 5100 Series and is the answer not in the manual?
General| Brand | Record |
|---|---|
| Model | 5100 Series |
| Category | Door Opening System |
| Language | English |
Connects the FPC-902 Hand Terminal to the Series 5100 control unit.
Presents the initial sequence of screens displayed on the FPC-902 during servicing.
Configures door type, motor selection, and lock type for system operation.
Sets battery type and related system operational parameters.
Adjusts door speeds, acceleration, deceleration, and creep section for movement control.
Configures holding force and ramp profiles for smooth door operation.
Manages time delays for door opening, remote signals, and SSK functions.
Configures door seal behavior and system reset functions.
Sets partial opening limits and obstruction sensitivity for door operation.
Identifies motor type and configures dual motor operation.
Configures door opening width and height measurements for the entrance system.
Manages battery operation modes and emergency response during power failures.
Selects door type and configures interlock system behavior.
Sets up parameters for connected mechanical control panels.
Configures display language and contrast levels for display modules.
Sets keyboard mode and brightness levels for the display panel.
Adjusts brightness levels for display modules and TD Backlite.
Determines the default operating mode for the system.
Configures locking functions and selects the lock type.
Manages start delay after unlocking and error checking for locking mechanisms.
Automatically identifies and displays connected CAN-BUS modules.
Configures specific input/output terminals and their associated functions.
Manages emergency stop reset and related input/output functions.
Configures SIO/SIS signals for door position and safety.
Configures SIA for safety signals and TOWA for partial opening.
Sets up push-to-actuate features and holding force for door operation.
Configures lead time parameters for door opening and closing sequences.
Configures time safety for inputs and alarm display settings.
Details procedures for resetting maintenance counters and programs.
Resets system parameters to factory or default settings.
Tests actuation from interior sensors and acquires safety beam characteristics.
Configures learning parameters and performs system resets.
Displays the current operational mode of the door system.
Accesses diagnostic data, error history, and parameter status.
Guides the user through setting up the flash programmer for software updates.
Verifies software versions for updates and checks stored software on the SD card.
Details the process for renewing system licenses.
Enables selection of the display language for the terminal.
