RED DEVIL 1400 - Test Operation; Anchoring the Pedestal Unit

10
Owner’s Manual:1400 & 1410
1787021 REV D
ECO 16-0082
May 2017
Air & Explosion
www.radiaproducts.com (PHONE) 800-221-1083 | (INTL) +1-763-533-2969 | (FAX) 763-533-0015
c. Clean the contacting surfaces of the
suction cups, and the oor where the cups will
make contact.
d. Apply an even layer of rubber cement
(or equivalent adhesive) to the contacting
surfaces of the suction cups and to the oor
directly under the cups.
e.
IMPORTANT: If the layer of rubber
cement is too thick, it won't dry proerly and
won't anchor the unit adequately.
f. Allow the cement to dry until it becomes
tacky.
g. Remove the 2' x 4's and lower the entire
machine to the oor. For long lasting adhesion,
allow the cement to dry overnight before
running the mixer.
h. Clean the contacting surfaces of the
suction cups, and the oor where the cups will
make contact.
8. If the pedestal unit walks (moves) during
operation the floor may be rough or uneven.
Anchor the base to the floor as follows:
a. Tilt the mixer and base backward until you
can insert a 2' x 4' board under the base. Make
sure the board is clear of the front suction
cups.
b. Tilt the mixer and base forward and insert
another 2' x 4' under the rear of the base.
Again, be sure the board clears the suction
cups.
Assembly and Test, Continued..
3.5 Test Operation