INSTALLATION & CONNECTIONS
Installation Environment
Theunitshould beinstalledina locationthatdoesnot exceedthemaximum
operatingtemperatureandprovidesgood aircirculation.Placing theunitnear
devices that generate excessive heat should be avoided.
Continuousexposure todirect sunlightmayacceleratetheaging processof
the bezel.
The bezel should b e cleaned only with a soft cloth and neutral soap
product. Do NOT use solvents.
Do not use tools of any kind (screwdrivers, pens, pencils, etc.) to operate
the keypad o f the unit.
Standard Unit Installation
Prepare the panel cutout to the dimensions shown in Figure 1, Panel
Installation & Removal. Remove the panel latch and cardboard sleeve from
the unit and discard the cardboard sleeve. The unit should be installed with
the bezel assembly in place. Insert the unit into the panel cutout. While
holding the front of the unit in place, push the panel latch over the rear of the
unitsothat thetabsof thepanellatchengage intheslotson thecase.Thepanel
latch should be engaged in the farthest forward slots possible. Tighten the
screws evenly until the unit is snug in the panel.
NEMA 4X/IP65 Unit Installation
The optional NEMA 4X/IP65 TCU Controller is designed to provide a
watertight seal in panels with a minimum thickness of 1/8 inch. The unit
meets NEMA 4X/IP65 requirements for indoor use, when properly installed.
The units are intended to be mounted into an enclosed panel. Prepare the
panel cutout to the dimensions shown in Figure 1, Panel Installation &
Removal. Carefully apply the adhesive side of the panel gasket to the panel
cutout. Remove the panel latch and cardboard sleeve from the unit. Discard
the cardboard sleeve. The unit should be installed with the bezel assembly in
place and the bezel screws tightened slightly. Insert the unit into the panel
cutout. While holding the front of the unit in place, push the panel latch over
the rear of the unit so that the tabs of the panellatch engagein the slots on the
case. The panel latch should be engaged in the farthest forward slot possible.
To achieve a properseal, tighten the latch screws evenlyuntilthe unit is snug
in the panel (Torque to approximately 7 in-lbs [79N-cm]). Do NOT
over-tighten the screws.
Note: The installation location of the controller is important. Be sure to keep it
away from heat sources (ovens, furnaces, etc.), away from direct contact with
caustic vapors, oils, steam, or any other process by-products in which
exposure may affect proper operation.
Caution: Prior to applying power to the controller, the internal AC power
selector switch must be set. Damage to the controller may occur if the switch is
set incorrectly.
To Next Page
Loading...
Need help?
General
