APPENDIX “F”- USER PARAMETER VALUE CHART
UNIT NUMBER
MNEMONIC PARAMETER
USER SETTING
SP Temperature Setpoint
OPOF Output Power Offset
OP Output Power
ProP Proportional Band
Intt Integral Time
dErt Derivative Time
Pb-2 Proportional Band #2
(secondary)
It-2 Integral Time #2 (secondary)
dt-2 Derivative Time #2 (secondary)
rtio Remote Setpoint Ratio
bIAS Remote Setpoint Bias
AL-1 Alarm 1
AL-2 Alarm 2
CONFIGURE INPUT
MNEMONIC PARAMETER
USER SETTING
tYPE Input Sensor Type
SCAL Temperature Scale Units
dCPt Temperature Resolution
FLtr Digital Filtering
SPAN Input Slope
SHFt Input Offset
SPLO Setpoint Lower Limit
SPHI Setpoint Upper Limit
SPrP Ramp Rate
InPt User Input
HCur Heater Current Scaling
CONFIGURE OUTPUT
MNEMONIC PARAMETER
USER SETTING
CYCt Cycle Time
OPAC Control Action
OPLO Output Power Lower Limit
Range
OPHI Output Power Upper Limit
Range
OPFL Sensor Fail Power Preset
OPdP Output Power Dampening
CHYS ON/OFF Control Hysteresis
tcod Auto-Tune Dampening Code
ANAS Linear Output Assignment
ANLO Linear Output Scale Value
ANHI Linear Output Scale Value
ANdb Linear Output Deadband
ANut Linear Output Update Time
To Next Page
Loading...
