APPENDIX “B” - SPECIFICATIONS AND DIMENSIONS
1. DISPLAY:Dual4-digit
Upper Temperature Display: 0.4" (10.2 mm) high red LED
Lower Auxiliary Display: 0.3" (7.6 mm) high green LED
Display Messages (Model dependent):
“OLOL” - Appears when measurement exceeds + sensor range.
“ULUL” - Appears when measurement exceeds - sensor range.
“OPEN” - Appears when open sensor is detected.
“SHrt” - Appears when shorted sensor is detected (RTD only)
“....” - Appears when display values exceed + display range.
“-...” - Appears when display values exceed - display range.
“SLid” - Appears when loss of slidewire signal is detected.
“VALV” - Appears when valve actuator error is detected.
2. POWER: Switch selectable 115/230 VAC (+10%, -15%) no observable
line variation effect, 48-62 Hz, 10 VA.
Figure 42, Dimensions
DIMENSIONS In inches (mm)
Note: Recommended minimum clearance (behind the panel) for panel latch installation is 5.5" (140)H x 2.1" (53.4)W.
To Next Page
Loading...
