CONFIGURE LOCKOUTS
MNEMONIC PARAMETER
USER SETTING
SP Access Setpoint
OP Access Output Power
dEv Access Deviation Display
HCur Access Heater Current Display
IN-2 Access Second Analog Input
Display
UdSP Access Display Units
Code Access Code Number
PID Access Primary PID Values
PID2 Access Secondary PID Values
rtbs Access Ratio and Bias Values
AL Access Alarm(s) Values
ALrS Enable Reset Alarm(s)
SPSL Enable Local/Remote Setpoint
Selection
trnF Enable Auto/Man Transfer
tUNE Enable Auto-tune
CONFIGURE ALARMS
MNEMONIC PARAMETER
USER SETTING
Act1 Alarm 1 Operation Mode
rSt1 Alarm 1 Reset Mode
Stb1 Alarm 1 Standby Enabled
AL-1 Alarm 1 Value
Act2 Alarm 2 Operation Mode
rSt2 Alarm 2 Reset Mode
Stb2 Alarm 2 Standby Enabled
AL-2 Alarm 2 Value
AHYS Alarm Hysteresis Value
CONFIGURE COOLING
MNEMONIC PARAMETER
USER SETTING
CYC2 OP2 Output Cycle Time
GAN2 Relative Cooling Gain
db-2 Heat-Cool Overlap/Deadband
CONFIGURE SERIAL COMMUNICATIONS
MNEMONIC PARAMETER
USER SETTING
bAUd Baud Rate
PArb Parity Bit
Addr Unit Address
Abrv Abbrev. or Full Transmission
PrAt Automatic Print Rate
PoPt Print Options
INP
SEt
OPr
Pbd
INt
dEr
AL1
AL2
dEv
OFP
r_P
Crg
Cdb
OSt
rAt
bIA
RSP
IN2
Pb2
It2
dt2
SP2
HCr
To Next Page
Loading...
