3. Rotate the module down flush with the rear of the adaptor module.
Figure: Press Module Flush
4.
Apply pressure and use a T20 TORX driver to rotate the lock on the adaptor module clockwise to the Lock
position.
REMOVE A DSMC POWER MODULE
REQUIRED TOOL(S): T20 TORX driver
1. Turn off the camera.
2.
Use a T20 TORX driver to rotate the lock on the adaptor module counterclockwise to the Unlock position.
3. Rotate the module upwards and away from the adaptor module to disengage.
4. Remove the module.
C OPYRI G HT © 2017 RED.C OM , LLC 955- 0038, REV-AD| 32
RED DSMC POWER OPERATION GUIDE
To Next Page
Loading...
Need help?
General
