RED DSMC SIDE HANDLE User Manual

QUICKPLATE MODULE
Figure: Quickplate Module
The Quickplate Module attaches to a +1 Adaptor Module or Module Adaptor to provide RED BRICK or REDVOLT-V
power support for EPIC/SCARLET. Unlike the Backpack Quickplate, the Quickplate Module does not require a LEMO
connector cable or Backpack Baseplate. Use a battery-equipped DSMC Side Handle or a DSMC AC Power Adaptor
to keep the camera running while hot swapping batteries.
The Quickplate Module also provides two (2) auxiliary ports to provide power for camera accessories. AUX ports draw
power from an attached RED BRICK or REDVOLT-V if one (1) is attached. If a RED BRICK or REDVOLT-V is not
attached, ports draw power from the BRAIN through the SEARAY connector.
WARNING: DO NOT attempt to power a third-party device without first verifying the cabling and connections are
correct, since that may cause damage. Damage to the device, this module, or other components of the camera
system caused by attempting to power a third-party device incorrectly may not be covered under warranty.
NOTE: The Quickplate Module requires that your camera is on firmware v5.1.14 or later.
C OPYRI G HT © 2017 RED.C OM , LLC 955- 0038, REV-AD| 42
RED DSMC POWER OPERATION GUIDE

RED DSMC SIDE HANDLE Specifications

General

Brand	RED
Model	DSMC SIDE HANDLE
Category	Camera Accessories
Language	English