EPIC/SCARLET ADAPTOR MODULES
This section describes the EPIC/SCARLET adaptor modules.
MODULE ADAPTOR
The Module Adaptor mounts to the back of the EPIC/SCARLET BRAIN and provides power and support for
connected modules. The Module Adaptor includes 1/4-20 mounting holes for customized configuration support. Most
EPIC/SCARLET modules require the use of an adaptor module.
WARNING: The Module Adaptor is NOT compatible with the +1 Adaptor Module.
+1 ADAPTOR MODULE
Figure: +1 Adaptor Module
The +1 Adaptor Module mounts to the back of the EPIC/SCARLET BRAIN, providing power and support for
connected modules. The +1 Adaptor Module also offers a 4-pin 0B LEMO
®
auxiliary power (DC) port for camera
accessories, and an EVF/LCD port for the use of an additional viewfinder or display.
WARNING: The +1 Adaptor Module IS NOT compatible with the Module Adaptor.
WARNING: DO NOT use the EVF/LCD port on the +1 Adaptor Module if a Pro I/O Module is connected to the
EPIC/SCARLET BRAIN. The Pro I/O Module overrides the EVF/LCD and AUX power out ports when connected.
WARNING: DO NOT attempt to power a third-party device without first verifying the cabling and connections are
correct, since that may cause damage. Damage to the device, this module, or other components of the camera
system caused by attempting to power a third-party device incorrectly may not be covered under warranty.
NOTE: The +1 Adaptor Module requires that your camera is on firmware v4.0.8 or later.
NOTE: Use a 4-Pin to 2-Pin Adaptor Cable to support 2-pin camera accessories.
C OPYRI G HT © 2017 RED.C OM , LLC 955- 0038, REV-AD| 26
RED DSMC POWER OPERATION GUIDE
To Next Page
Loading...
Need help?
General
