DSMC2 V-LOCK BATTERY MODULE
Figure: DSMC2 V-Lock Battery Module
The DSMC2 V-Lock Battery Module is a low profile cable-free module that enables you to power your DSMC2 BRAIN
and camera accessories using RED BRICK or REDVOLT-V and third-party batteries. The V-Lock and protected release
button ensure ongoing power even during mobile shoots.
This DSMC2 battery module also offers a P-Tap connector for powering peripherals and accessories. Located on the
top of the module, the P-Tap connector supports a maximum current of 3.0 Amps.
Manufactured from robust aluminum alloy, this DSMC2 battery module offers a blend of utility and power support in a
lightweight and space-saving form factor. The DSMC2 V-Lock Battery Module is an ideal power solution for use with
most DSMC2 expanders. Alternatively, connect the DSMC2 V-Lock Battery Module directly to your DSMC2 BRAIN for
a low-profile, battery-only power configuration.
WARNING: DO NOT attempt to power a third-party device without first verifying the cabling and connections are
correct, since that may cause damage. Damage to the device, this module, or other components of the camera
system caused by attempting to power a third-party device incorrectly may not be covered under warranty.
INSERT A BATTERY
1. Align and insert the RED BRICK or REDVOLT-V.
2. Apply pressure to the battery until a click is heard, signaling the battery is properly seated.
REMOVE A BATTERY
1.
Press the Eject button to the left of the DSMC2 V-Lock Battery Module.
2. Remove the battery.
C OPYRI G HT © 2017 RED.C OM , LLC 955- 0038, REV-AD| 53
RED DSMC POWER OPERATION GUIDE
To Next Page
Loading...
Need help?
General
