TURN ON THE CAMERA
NOTE: If you have just turned off the camera, wait at least three (3) seconds before turning the camera back on.
1. Attach a power source to the camera.
The Power Status LED illuminates red, indicating that an appropriate power source is connected.
2.
Press and release the PWR/REC key on the right side of the camera.
The Power Status LED turns off, and within five (5) seconds illuminates yellow as the camera turns on.
The Power Status LED then illuminates green to confirm that the camera is turned on and ready to use.
NOTE: The Power Status LED flashes red when there is less than five (5) minutes of operating time remaining.
TURN OFF THE CAMERA
Use one of the following methods to turn off the camera:
Go to Menu > Power and select Shutdown.
Press and hold PWR/REC until the Shutting Down... notification shows on the display.
NOTE: The camera turns off automatically if the supply voltage drops to 11.5 V.
POWER STATUS
The power status of the current primary power source displays in the Lower Status Row of the graphical user interface
(GUI). Navigate to the Power In menu at Menu > Power > Power In for the status of all connected power sources.
C OPYRI G HT © 2017 RED.C OM , LLC 955- 0038, REV-AD| 8
RED DSMC POWER OPERATION GUIDE
To Next Page
Loading...
Need help?
General
