RED DSMC OPERATION GUIDE
COPYRIGHT © 2015 RED.COM, INC 955-0020_V6.0, REV-D | 141
PRE-AMP
The pre-amplifier range is 30 dB to 60 dB. The default is 32 dB. To adjust amplification levels, follow the
instructions below:
1. Go to Menu > Settings > Audio > Pre-Amp.
2. Move the Pre-Amp (pre-amplifier) sliders up and down to adjust the amplification levels.
NOTE: To link the amplification for each channel, go to Menu > Settings > Audio > Channel and select the Gain
Sliders check box. For more information, go to “Link” on page 140.
To Next Page
Loading...
