RED EPIC-M RED DRAGON

To Next Page

To Previous Page

RED DSMC OPERATION GUIDE

SHARPNESS

Control the sharpness of each monitor output. Move to the left for a sharper image; move to the right for a less

sharp image.

CURVES

Define the individual curves for the Luma, Red, Green, and Blue channels. You can only adjust one (1) curve at

a time. Select Reset Curve to reset a curve.

NOTE: Luma is the only channel on BRAINs with MONOCHROME or RED DRAGON MONOCHROME sensors.

COLOR/GAMMA

Adjust the monitor output Color Space and Graded Gamma curves. These settings affect metadata only, and

can be changed in REDCINE-X PRO.

COLOR SPACE AND GRADED GAMMA SPACE

RED recommends using the most recently released Color Space and Graded Gamma settings. Use legacy

settings (such as REDcolor2) only if you need to record footage to match footage that you recorded with that

legacy setting.

For more information, see the Understanding REDlogFilm and REDgamma article, available at www.red.com/

learn/red-101/redlogfilm-redgamma.

INDEPENDENT DISPLAY LUT

NOTE: Independent Display LUT is disabled when a REDCAST Module is attached.

NOTE: When Independent Display LUT is enabled, the menu may change from light gray to dark gray. The

camera applies the color and gamma spaces after rendering the user interface, so changing these settings

affects the user interface.

Independent Display LUT allows you to apply a different gamma space to each monitor (this feature does not

apply a LUT). You can record via HD-SDI or HDMI, apply a LUT through a LUT box, and then view a different

look on each monitor.

USE THE INDEPENDENT DISPLAY LUT FEATURE

To set up the Independent Display LUT feature, follow the instructions below:

1. Go to Menu > Settings > Look > Color/Gamma.

2. Select the Independent Display LUT check box.

RED EPIC-M RED DRAGON - Page 79