Reely Rat Max XL - Stopping the Vehicle

48
Pulling the throttle/brake lever from forwards to reverse without a pause will activate the brakes (the vehicle will not
reverse).
Intheeventofanimmediateswitchfromforwardstoreverse,thethrottle/brakelevermustrstbepushedawayfrom
the handle and then moved to the neutral position (if the vehicle moves forwards during this phase, braking is also
activated as a result). If the throttle/brake lever is pushed away from the handle a second time, the vehicle drives in
reverse.
After driving forwards, the vehicle only drives in reverse if the throttle/brake lever is pushed away from the
handleasecondtime.Thisisrequiredbythebrakefunction;inaddition,itprotectsthedrivemechanism
from overload due to an immediate switch from forwards to reverse.
Move the throttle/brake lever on the remote control very carefully and drive slowly until you are familiar with
how the vehicle responds to the remote control. Do not make sudden adjustments to the remote control
levers.
 Neverpointtheremotecontrolantennadirectlytothevehicle,asthisgreatlyreducestherange.Thegreat-
est range is obtained when the remote control and vehicle antennas are upright and parallel to each other.
If the vehicle shows a tendency to move to one side, adjust the steering trim on the remote control accord-
ingly.
Discontinue use immediately if the vehicle does not respond as expected, or if the vehicle stops responding
to the remote control. If this occurs, the drive/remote control batteries may be nearly empty, or the vehicle
may be too far from the remote control.
A coiled/damaged receiver aerial, disturbances on the radio channel used (e.g. other models, radio trans-
missions from other devices, Bluetooth
®
, WLAN) or adverse transmission/reception conditions could also
be a cause of unusual vehicle responses.
Before you replace the empty drive battery with a fully charged battery and continue the journey, it is essen-
tialtowaitatleast5-10minutesuntiltheengineandthespeedcontrollerhavecooleddownsufciently.
g) Stopping the vehicle
Tostopthevehicle,proceedasfollows:
• Release the throttle/brake lever on the remote control so that it is in the neutral position, and then let the vehicle
coast to a standstill.
• Waituntilthevehiclehasstopped,andthenswitchoffthespeedcontroller(movetheswitchtothe"OFF"position).
Do not reach into the wheels or drive components or move the throttle/brake lever on the remote control.
Do not hold the vehicle by the wheels!
Caution!
 Theengine,speedcontrolleranddrivebatterybecomeveryhotduringuse!Donottouchthesepartsim-
mediatelyafteruse–burnhazard!
• Disconnect the drive battery from the speed controller. Unscrew the plug-in connection completely.
• Thenswitchofftheremotecontrol.