Reely Rat Max XL - Programming the Speed Controller; Adjusting the Neutral and Full Throttle Setting

49
10. Programming the speed controller
a) Adjusting the neutral and full throttle setting
If the vehicle does not stay stationary when the throttle/brake lever is in the neutral position, the throttle trim can be
adjusted on the transmitter.
Ifthetrimsettingisinsufcient(orifthetrimisalmostintheendposition),youcanre-programtheneutralandfull
throttle positions for driving forwards and backwards.
Proceed as follows:
• Switch on the remote control and leave the throttle/brake lever in the
neutral position. Set the trim for the drive function to the neutral posi-
tion.
• Switch on the speed controller using the on/off switch (A). Hold down
the setup button (B) and turn on the speed controller (move the switch
tothe"ON"position).
• TheLEDonthespeedcontrollerwillthenashredandtheenginewill
emit beeps. Release the setup button.
If you do not release the setup button, programming mode will be ena-
bledafterafewseconds,asdescribedinchapter"b)Programmingadditionalfunctions"onpage50.Inthiscase,
turn off the speed controller and proceed again as described above.
Beeps are generated by a brief activation of the brushless motor.
• Release the throttle/brake lever on the transmitter so that it is in the neutral position.
• Ifyoupressthesetupbutton(B)briey,theLEDonthespeedcontrollerwillashgreenoncebrieyandyouwill
thenhearabeep.Theneutralpositionhasbeensaved.
• Move the throttle/brake lever to the full forwards throttle position (move it towards the handle and hold it in place).
Caution!
If you do not move the throttle/brake lever on the transmitter or do not move it far enough during program-
ming, the vehicle may respond to even minute movements of the throttle/brake lever on the transmitter or
become uncontrollable upon completion of programming. In this case, reprogram it.
• Ifyoupressthesetupbutton(B)briey,theLEDonthespeedcontrollerwillashgreentwicebrieyandyouwill
thenheartwobeeps.Thefullforwardsthrottlepositionwillbesaved.
• Move the throttle/brake lever to full reverse throttle (push the lever away from the handle as far as it will go).
• Ifyoupressthesetupbutton(B)briey,theLEDonthespeedcontrollerwillashgreenthricebrieyandyouwill
thenhearthreebeeps.Thefullreversethrottlepositionwillbesaved.
• Release the throttle/brake lever to return it to the neutral position.
• Waitforatleastthreeseconds.Thespeedcontrollerwillautomaticallyexitsettingsmodeandapplythenewset-
tings.