Reer MOSAIC M1 - Calculation of safety distance of an ESPE connected to MOSAIC

MODULAR SAFETY INTEGRATED CONTROLLER MOSAIC
8540780 • 10/07/2020 • Rev.38 19
English
RESTORE function
If the M1 or M1S unit is damaged, you can replace it with a new one; having already saved
all the configurations on the MCM, all you need to do is insert the MCM in the new M1/M1S
and switch on the MOSAIC system, that will immediately load the backup configuration. In
this way, the work interruptions will be minimized.
Compatibility between MCM memory and Master modules:
 M1S can load configurations from MCM if it is written by a M1S or M1
 M1 can load configurations from MCM only if it is written by a M1

The LOAD and RESTORE functions can be disabled via SW. (see Figure 54)
 Each time MCM is used, carefully check that the chosen configuration is the one that was
planned for that particular system. Try again a fully functional test of the system composed of
Mosaic plus all devices connected to it (see the "TESTING the system" section).
Module MI8O2
TERMINAL
SIGNAL
TYPE
DESCRIPTION
OPERATION
1
24VDC
-
24VDC power supply
-
2
NODE_SEL0
Input
Node selection
Input ("type B" according to EN 61131-2 )
3
NODE_SEL1
Input
Input ("type B" according to EN 61131-2 )
4
0VDC
-
0VDC power supply
-
5
OSSD1_A
Output
Static output 1
PNP active high
6
OSSD1_B
Output
PNP active high
7
RESTART_FBK1
Input
Feedback/Restart 1
Input according to EN 61131-2
8
OUT_STATUS1
Output
SIL 1/PL c output
PNP active high
9
OSSD2_A
Output
Static output 2
PNP active high
10
OSSD2_B
Output
PNP active high
11
RESTART_FBK2
Input
Feedback/Restart 2
Input according to EN 61131-2
12
OUT_STATUS2
Output
SIL 1/PL c output
PNP active high
13
OUT_TEST1
Output
Short circuit detection output
PNP active high
14
OUT_TEST2
Output
Short circuit detection output
PNP active high
15
OUT_TEST3
Output
Short circuit detection output
PNP active high
16
OUT_TEST4
Output
Short circuit detection output
PNP active high
17
INPUT1
Input
Digital input 1
Input according to EN 61131-2
18
INPUT2
Input
Digital input 2
Input according to EN 61131-2
19
INPUT3
Input
Digital input 3
Input according to EN 61131-2
20
INPUT4
Input
Digital input 4
Input according to EN 61131-2
21
INPUT5
Input
Digital input 5
Input according to EN 61131-2
22
INPUT6
Input
Digital input 6
Input according to EN 61131-2
23
INPUT7
Input
Digital input 7
Input according to EN 61131-2
24
INPUT8
Input
Digital input 8
Input according to EN 61131-2
Table 4