Regency P36E-NG4 - Wiring Diagrams

P36E-4 Zero Clearance Direct Vent Gas Fireplace
48
WIRING DIAGRAMS
This heater does not require a 120V A.C. supply for operation. In case of a power failure, the burner switch and the optional remote control/
thermostat will continue to operate. However, a 120V A.C. power supply is needed for the fan/blower operation.
(Do not cut the ground terminal off under any circumstances.)
NOTE: Even if the fan is not purchased with the unit, it is still a good idea to bring power to the receptacle box (provided with the unit)
in case the fan is installed at a later date.
Proflame System
Configuration
886 GTMF
Wire Diagram
INSTALLATION
SureFire™ Switch
Proame System
886 ON/OFF Stand Alone
Illustrated Wire Diagram
Surere Switch
(IPI / CPI)
Standard Main ON/OFF
Switch or Optional Wall Switch
Battery Holder
Pilot Ground Wire
Chassis Ground
EI Pilot
Sense Electrode
Spark Electrode
DFC Wire Harness Assembly
Proame DFC Board
886 Proame Valve
Note: 4 AA batteries must be
installed to operate the burner
switch.
Do not use a 9 volt battery.
IMPORTANT:
If the optional remote control is used, the AA batteries normally installed into the battery holder must be removed. The AA batteries in the
receiver now operate the unit. Having AA batteries in both the battery holder and receiver will damage the gas valve.