What to do if Rena T-250 Power Tool media does not feed properly?
If the media does not feed properly, consider these possible causes and solutions: * Check the setup of the separator bar, as it might be improperly set up. * Clean the feed rollers if they are glazed or dirty. * Adjust the side guides if they are too tight.
What to do if Rena T-250 Power Tool media skews when feeding?
If the media skews when feeding, it could be due to the following reasons: * The side guides might be too loose, in which case you should tighten them. * The separator bar might not be set evenly; ensure it is.
Why does my Rena T-250 feed media without tabs?
If your device feeds media without tabs, consider the following: * Ensure the Tab Feed Switch is turned ON. * Replace the tabs if you are out of tabs. * Adjust the tab sensitivity if it is incorrect. * Turn ON the Tab Pressure knob if it is in the OFF position. * Make sure that the tabs peel off the backing.
Why does Rena T-250 place multiple tabs on media?
If multiple tabs are being placed on the media, it might be because: * The tabs are not centered in front of the sensor holder centerline; center them. * The tab sensitivity adjustment is incorrect; adjust it accordingly.
How to fix inconsistent tab placement on Rena Power Tool?
To correct inconsistent tab placement, consider the following: * Correctly thread the tabs. * Center the tabs in front of the sensor holder. * Tighten the Tab Roll on the spindle if it is loose. * Clean the rollers if they are dirty or glazed.
What causes Rena Power Tool tab placement to move side to side?
If the tab placement moves side to side, it could be due to: * Loose side guides; tighten them. * Improperly set moveable post/Sensor Holder; adjust it.
What causes Rena T-250 tabs stream feed?
If the tabs stream feed, it may be because the Tab Pressure knob is in the OFF position. Turn ON the Tab Pressure knob.
Why won't my Rena T-250 turn on?
If the power is not on, ensure that: * The unit is plugged in. * The fuse is not blown; replace it if it is.
What to do if the tab sensitivity LED does not illuminate on Rena Power Tool?
If the tab sensitivity LED does not illuminate, the power might not be on. Turn on the power.
General| Brand | Rena |
|---|---|
| Model | T-250 |
| Category | Power Tool |
| Language | English |
To Next Page