Rena T-250 - Section 1- Introduction; General; Front View

GETTING ACQUAINTED
1
Section 1 – Getting Acquainted
General: The T-250 Tabber is a desktop tabbing machine that is designed for the
moderate volume user. It can handle documents ranging from 3” x 5” card stock to 11” x
11” booklets up to 5/32”
The T-250 Tabber will process a range of “Tabs” in most colors and either round or
square from 5/8” to 1-1/4” in length and width.
Front View
1.
Tab Sensor and Guide Assembly – This assembly keeps the tab aligned so that
the sensor can sense the tab.
2.
Tab Roll Side Guide – Holds the tab roll in place on the Tab Roll Support.
3.
Reel Brake Assembly – Prevents the roll of tabs from unwinding when they are
not being fed.
4.
Tab Take-up Reel – Winds up the tab backing material.
5.
Metering Bracket Assembly – Separates the media so that only one piece feeds
at a time
6.
Tracking Rollers – Guide the media through the tabber.
7.
Tab Positioning Adjustment Knob – Adjusts the position the tab on the media.
8.
Tab Pressure Knob – Provides pressure on the tab to hold it against the tab
advance roller.
9.
Tab Advance Knob – Attached to the tab advance roller that feeds the tabs.
10.
Exit Roller – Applies pressure to the tab to help it stick to the media.