Renault TRAFIC 2024 - Page 189

STARTING, STOPPING THE ENGINE
3
Driving - 187
Special feature of the automatic
engine re-start
Beforeleavingthevehi
cle, the engine must be
stopped (not put in
standby) 🡺180.
Under certain conditions, the engine
canrestartonitsowninordertoguar
antee your safety and comfort.
This may occur when:
– the outdoor temperature is too low or
too high;
– the "Clear View" function is activated
🡺290;
– the battery is not sufficiently
charged;
– the vehicle speed is above 3 mph (5
km/h) (downhill slope, etc.);
– thebrakepedalispressedrepeated
lyorthereisabrakingsystemrequire
ment;
– ...
Depending on the vehicle, the
warninglightisdisplayedonthein
strumentpaneltonotifyyouofauto
matic engine restarting.
Depending on the vehicle, the
warning light may be accompanied by
a message on the instrument panel:
– "Batterychargeoptimisation"topri
oritise battery charging;
– "Heating comfort priority" to prioritise
the air conditioning;
– "Engine running priority" to prioritise
engine functions.
Special note:withtheen
gine on standby, press
switch 1 to automatically
restart the engine.
Deactivating,activatingthefunc
tion
Press the switch 1 to deactivate the
function.The"Stop&Startdeactivat
ed"messageappearsontheinstru
ment panel and the built-in indicator
light 2 on the switch 1 lights up.
Pressingagainwillreactivatethesys
tem.The"Stop&StartActivated"mes
sage appears on the instrument panel
and the built-in indicator light 2 on the
switch 1 goes out.
Thesystemisautomaticallyreactivat
ed each time the vehicle is deliberately
started 🡺180.
Operating faults
Whenthe"CheckStop&Start"mes
sage appears on the instrument panel,
accompanied by the illumination of the
built-in indicator light 2 on the switch
1 ,thisindicatesthatthesystemisde
activated.
Consult an approved dealer.