Renault TRAFIC 2024 - Tyre Pressure Monitoring System; Operating Principle

TYRE PRESSURE MONITORING SYSTEM
3
204 - Driving
Operating principle
Ifthevehicleisequippedwiththefunc
tion, this system monitors the tyre
pressure.
Each wheel (except for the emergency
sparewheel)hasasensorintheinfla
tion valve which periodically measures
the tyre pressure.
Thesystemdisplaysthecurrentpres
sures on the instrument panel 1 and
alertsthedriverintheeventofinsuffi
cient pressure.
Resetting the standard level for
the tyre pressures
This should be performed:
– when the standard tyre pressure
needstobechangedtoadapttous
age conditions (empty, carrying a load,
motorway driving, etc.);
– after swapping a wheel (however,
this practice is not recommended);
– after changing a wheel.
Itshouldalwaysbedoneaftercheck
ing the tyre pressure of all four tyres
when cold.
Tyre pressures must correspond to the
current usage of the vehicle (empty,
carrying a load, motorway driving,
etc.).
If the wheels are swapped,
thesystemmustbereini
tialised.Consultanap
proved dealer.
Resetting procedure
Ignition on, vehicle stopped:
– press switch 5 as many times as
necessary to reach the "VEHICLE" tab
;
– briefly press switch 2 or 3 repeated
ly to reach the "Tyre Pressure" page;
– press and hold (around 3 seconds)
on the control 4 to launch the reset.
The flashing tyres symbol followed by
the"LearningTyrePressures"mes
sage indicates that the request to reset
thetyrepressurehasbeenacknowl
edged.
Resetcantakeseveralminutesofdri
ving.