Renault TRAFIC 2024 - Activating Cruise Control

CRUISE CONTROL
3
Driving - 255
Press switch 1 until the warning
lightisdisplayedingreenonthein
strument panel. The "Cruise control
ON"messageappearsontheinstru
ment panel accompanied by dashes to
indicate that the cruise control function
is in operation and waiting to store a
cruising speed.
Activating cruise control
While the vehicle is moving a steady
speed (above approximately 19 mph
(30 km/h)), press the 2 (SET/-) switch
or the 3 (RES/+): switch: the function
is activated and the current speed is
taken into account.
Thecruisingspeedreplacesthedash
es. Cruise control is confirmed when
the memorised speed and warning
light appear in green .
If you try to activate the function below
19mph(30km/h),themessage"In
valid Speed" will be displayed and the
function will remain inactive.
Note: the cruise control speed can be
changedatanytimeaslongastheve
hicle speed is between 19 mph and
112 mph (30 km/h and 180 km/h).
Driving
Please note that you
must keep your feet
closetothepedalsinor
dertoreactinanemer
gency.
Once a cruising speed is registered
andthecruisecontrolfunctionisac
tive,youmayliftyourfootofftheaccel
erator pedal.
Adjusting the cruising speed
The cruising speed may be changed
by repeatedly pressing the:
– switch 2 (SET/-) to reduce the
speed;
– switch 3 (RES/+) to increase the
speed.
Note: press and hold one of the
switchestomodifyspeedbysucces
sive increments.
Exceeding the cruising speed
The cruising speed may be exceeded
atanytimebydepressingtheacceler
ator pedal.
While it is being exceeded, the cruising
speed flashes in red on the instrument
panel. Then, release the accelerator
pedal: after a few seconds, the vehicle
willautomaticallyreturntoitssetcruis
ing speed.
You must keep your
feet near the pedals to
be ready to react in an
emergency.
If the cruise control is no
longer available (after
severalattemptstoacti
vateit),contactanAp
proved Dealer.