ADDITIONAL DRIVING AID FUNCTIONS
3
Driving - 237
Temporarily not available
If the system detects a temporary fault
the warning light illuminates, or
depending on the vehicle, the
warning light illuminates in yellow on
the instrument panel.
The possible causes are:
– the system is temporarily blinded
(glare from the sun, dipped beam
headlights, bad weather conditions
etc.). The system will be operational
again when visibility conditions are
better;
– the system is temporarily interrupted
(e.g. the windscreen or the front or
rear bumper is obscured by dirt, mud,
snow, condensation, etc.). In this case,
parkthevehicleandswitchofftheen
gine. Clean the windscreen and front
bumper.Whenyounextstarttheen
gine,thewarninglightandthemes
sage go out.
If this is not the case, this may arise
fromanothercause;contactanAp
proved Dealer.
Operating faults
If the function detects an operating
fault, the warninglightor,de
pending on the vehicle, the
warninglightappearsontheinstru
ment panel accompanied by the
"CheckFrontcamera"or"Checkcam
era" message.
Consult an approved dealer.
press switch
4
and repeatedly
press control
5
or
6
to reach the
tab;
–
depending on the vehicle, press the
switch
7
OK;
–
repeatedly press control
5
or
6
to
reach the menu, then press
the switch
7
OK;
–
repeatedly press control
5
or
6
to
reach the "DRIVING AIDS" menu,
then press the switch
7
OK;
–
repeatedly press control
5
or
6
to
reach the "Active braking sensitivity"
menu, then press switch
7
OK;
–
press control
5
or
6
repeatedly to
adjust the setting. Press switch
7
OK.
–