TYRES
6
342 - Practical advice
60km/h)inordertodistributetheprod
uct evenly in the tyre. After driving a
distanceof2miles(3km),stoptheve
hicle and check the tyre pressure;
– if the pressure is higher than 1.3 bar
butlowerthantherecommendedpres
sure (see the label affixed to the edge
ofthedriver'sdoor),adjustit.Other
wise, contact an approved dealer: the
tyre cannot be repaired.
Precautions when using the kit
The kit should not be operated for
more than 15 consecutive minutes.
The container must be replaced after
thefirstuseevenifliquidremainsin
side.
Following repair with the
kit, do not travel further
than 124 miles (200 km).
In addition, reduce your
speedandundernocircum
stances exceed 50 mph (80 km/
h).Thesticker,whichyoumustaf
fix in a prominent position on the
dashboard, reminds you of this.
Depending on the country or local
legislation, a tyre repaired with
theinflationkitwillneedtobere
placed.
Please be aware that a
poorlytightenedormiss
ing valve cap can make
the tyres less airtight and
may lead to pressure loss.
Always use valve caps identical to
the originals and screw them
down fully.
Tools
Do not leave the tools
unsecuredinsidetheve
hicle as they may be
projected during brak
ing. After use, check that all the
tools are correctly clipped into the
tool kit, then position it correctly in
its housing to reduce the risk of
injury.
Nothing should be
placed on the floor (area
in front of the driver) as
these objects may slide
under the pedals during sudden
brakingmanoeuvres,thusob
structing their use.
Thetoolsincludedinthetoolkitde
pend on the vehicle. The tool kit
2
is
located under the driver's seat. To take
it out, move the seat forward and fold
down the seatback 🡺54. Loosen the
mounting bolt
1
from the unit and
swivel it to extract it.
Jack
3