REAR SEATS
4
|
114 - Your comfort
– Follow the same steps in reverse
manner to assemble the seat backrest.
NOTE: Gap
3
between third row seat
back and cushion will allow the cus-
tomer to grab the seatback and remov-
ing them.
To remove the third row cushion
Follow the steps after removing the
backrest;
– Pull the strap
2
and lift the cushion
vertically to a certain angle as shown
in illustration
B
;
– Lift the seat cushion upwards in the
same orientation to disassemble the
seat cushion. Ensure that the mount-
ing brackets comes out completely
from the floor on both ends;
– Follow the same steps in reverse
manner to assemble the seat cushion
When refitting the seat
back, make sure it is
correctly locked in place.
If seat covers are fitted,
make sure these do not prevent
the seatback latch from locking in.
Make sure that the seat belts are
positioned correctly. Reposition
the headrests.
Make sure that the seat-
back is correctly locked.
If necessary, remove any
obstacles behind the
seats. Repeat the above until the
seat is locked correctly.
It is not permitted to dri-
ve with one of the third
row seats folded down if
a passenger is in the
other third row seat.
Risk of injury
Do not attempt to remove
the third row headrest when
the tail gate is closed as it
may break the tail gate glass.
Make sure the third row
headrest is in lowered con-
dition while closing the tail
gate.
To Next Page
Loading...
